Here are the steps required to install the SellerFusion application and setup
your trial:
|
 |
| STEP 1 - |
Check that you have Microsoft .NET Framework 1.1
or better installed on your computer.
|
| STEP 2 - |
Check that you have the Microsoft Compact Framework
installed on your PDA. Many newer PDAs come with it
pre-installed.
Instructions for downloading and installing it may be found .
|
| STEP 3 - |
Download the Fusion Application Installer. Click to download the file.
|
| STEP 4 - |
Connect your PDA to your computer using and run the installer. Be sure to install to your storage
card, not your device's memory.
|
| STEP 5 - |
When the installer finishes, launch the application on the PDA by clicking
the Fusion icon in Programs. It looks like this:
After clicking the icon, you should see the following screen:
|
| STEP 6 - |
If you do not see the above screen, PANIC.
Just kidding. There's plenty of time to panic later. Go back to STEP
1 and try again.
Make a note of any error messages or problems you encounter.
Send email to
.
If you do see this screen, congratulations, you have successfully installed the
application.
|
| STEP 7 - |
Get data for your device. You can skip this step if you only
want to use live data lookups.
If you want to use the local database features, you will need to download the
datafiles. There are multiple ways to do this.
Click the links below for instructions on each method.
|
| STEP 8 - |
Register your device. If your device can access the
internet,
follow .
If you do not have internet access on your device,
follow .
|
| STEP 9 - |
THERE IS NO STEP 9.
If you have made it this far, you have completed installing the
database application.
|